INSTRUCTIONS LEDT-346C,CB,CR,CS
ipcw.com
06-09 H3 LED TAIL LIGHTS
Your new IPCW L.E.D. TAILLIGHT are quality-made products that will work beautifully on your vehicle.  Please refer to the
pictures below for installation.
1.
2.
3.
4.
Open liftgate to remove the screws on stock tail lights.  Keep the screws for Step 10. Remove stock tail light. Twist open the sockets on the back of stock light. Remove and discard ONLY the light bulb from the Running light. (the top socket)
5.
6.
7.
8.
Keep the bulb on the reverse light connected. Take (IPCW) L.E.D. Taillight out from box. Gently pull out the Running light connector from LED taillight. Plug this connector to vehicles Running light socket. Make sure to match up the wires match (Black to Black).
9.
10.
11.
Twist in both sockets from the vehicle wiring harness and make sure they are sealed. Make sure the light functions properly, then install the screws kept from Step 1.
Text Box: NOTE:
INSTALLING L.E.D. LAMPS
After you have installed the new lamps, you should:
1.  Test the lights to make sure all L.E.D. bulbs light up.
2.  Check to make sure the Cruise Control operates (if the vehicle is equipped).  
Need More Technical Support?
If the vehicle experiences any of the following conditions after you have done these procedures, please feel free to contact us at (323)838-5588.  You will be able to speak with someone.  Or if you prefer, you can e-mail us at technical@inprocarwear.com.  We will be more than happy to provide you with the technical support you need.
1.  The warning lights on the dashboard lights up (example: ABS, Cruise Control, or maintenance lights).
2.  The turn signals flash much rapidly than normal.
Done!  Thank you for your purchase.  We hope you enjoy your new IPCW LED TAILLIGHTS.
(Show with LEDT-2038CR Ruby Red)