INSTRUCTIONS LEDT-2040C,CB,CS
ipcw.com
05-UP TACOMA LED TAIL LIGHTS 
Your new IPCW L.E.D. Taillights are quality-made products that will work beautifully on your vehicle.  Please refer to the
pictures below for installation.
1.
2.
3.
4.
Pull down tailgate and remove 10mm screws from both sides. Very gently, pull light away from bed of truck. Twist & unlock all 3 sockets. Remove the top 2 bulbs.
5.
6.
7.
8.
Twist & unlock the bottom socket. Reverse light bulb stays on socket. Using needle nose pliers, pinch  clamp together to release wire harness from factory light. Take IPCW LED taillight out of box.  Top socket is a 2-wire socket.  Match the BLACK wire on LED connector to the WHITE and BLACK STRIPED wire on factory socket and plug it in.
9.
10.
11.
12.
Make sure plug is connected correctly into socket, then twist socket tightly to seal the light. Middle socket is a 3-wire socket. Match the BLACK wire on LED connector to the WHITE and BLACK STRIPED wire on factory socket and plug it in. Twist & lock Reverse Light socket into place. After all 3 sockets are connected to LED taillight, install the light on vehicle using steps 1-4 in reverse order.
Text Box: NOTE:
INSTALLING L.E.D. LAMPS
After you have installed the new lamps, you should:
1.  Test the lights to make sure all L.E.D. bulbs light up.
2.  Check to make sure the Cruise Control operates (if the vehicle is equipped).  
Need More Technical Support?
If the vehicle experiences any of the following conditions after you have done these procedures, please feel free to contact us at (323)838-5588.  You will be able to speak with someone.  Or if you prefer, you can e-mail us at technical@inprocarwear.com.  We will be more than happy to provide you with the technical support you need.
1.  The warning lights on the dashboard lights up (example: ABS, Cruise Control, or maintenance lights).
2.  The turn signals flash much rapidly than normal.
(Shown in Crystal Clear #LEDT-2040C)
Done! Thank you for your 
purchase. We hope you enjoy
your new IPCW LED taillights.