INSTRUCTIONS		LED3-2037B, C, R, S				ipcw.com
	07-UP TUNDRA		L.E.D. THIRD BRAKE LIGHT
			WITH CARGO LIGHT
	Your new IPCW L.E.D. 3rd brake Light is a quality-made product that will work beautifully on your vehicle.  Please refer to the
	pictures below for installation.
1.		2.		3.		4.
	Remove 10MM screws from backdoor pillars on both sides & unclip pillars.		Very gently start to unclip & loosen headliner.		Make sure clips remain on the headliner, for re-installation.		Pull headliner down to get access to the rear of the 3rd brake light.
5.		6.		7.		8.
	Use a 10mm socket wrench to loosen nuts from rear of 3rd brake light. (Inner sheet metal)		Use a 10mm socket & socket extension only to remove nuts. No socket wrench needed.		Unscrew & remove factory lens.		In the inner part of factory light, use a screwdriver to unclip the light.
9.		10.		11.		12.
	Remove base & light from the truck cab.		Disconnect factory light from factory plug.		Remove (IPCW) L.E.D. 3rd brake light from box.		Connect (IPCW) light to factory plug. For re-install, repeat steps 1-6 in reverse order.
					Done! Thank you for your
					purchase. We hope you enjoy
					your new IPCW LED LIGHTS.
					(Shown in Ruby Red #LED3-2037R)